Anneal Ovens
The aluminum anneal oven is a type of post-processing heat-treatment equipment used to anneal (soften and relieve stress in) aluminum profiles after they have been extruded, cold drawn, or bent. High-power fans circulate hot air throughout the chamber, while a PLC multi-zone closed-loop control system maintains a steady temperature difference of ±3-5°C. It is suitable for a wide range of aluminum alloys, including 6063, 6061, 5052, 3003, and others, and is the primary equipment for managing the soft/hard state of aluminum and stabilising product performance.
Specifications
| Model | Basket size (mm) | Heating time (min) | Max. load per cycle (T) | Temp. difference (°C) | Energy (m³/t) | Total power (kW) |
| To customer spec | 180 | 10 | ≤±4 | 18 | 70 | |
| To customer spec | 180 | 15 | ≤±4 | 18 | 90 | |
| Configuration option: heating by natural gas, LPG, all-electric, or gas + electric hybrid. | ||||||
Complete Process Flow
- Load and seal: profiles enter the chamber, and a cylinder locks the furnace door.
- Ramp-up: even heating along the process curve (280-420 °C) to avoid thermal gradient stress.
- Constant-temperature reconstruction: soak for 2-6 hours; recrystallisation reduces internal stress and work hardening, resulting in a homogeneous structure.
- Staged slow cooling: slow-cooling inside the furnace to 200°C before discharge, while tightly managing the cooling rate to avoid adding fresh distortion stress.
- Finished-product inspection: hardness, ductility, and straightness checked.
Advantages
- Removes work hardening
Recrystallises the grain structure to repair the hard, brittle state caused by extrusion and cold working, significantly enhancing ductility for downstream bending, stamping, and drawing while lowering scrap rates. - Relieves residual stress
Eliminates internal tension created during forming and straightening, eliminating warping during subsequent machining or anodising, and ensuring that precise component dimensional tolerances remain consistent over time. - Precise hardness control
The oven can generate different material states O-temper (soft) and H14/H24 (half-hard) by adjusting the annealing temperature and soak time, balancing bendability and structural strength to satisfy a variety of order kinds. - Uniform heat treatment
High-volume full-chamber hot-air circulation with a guided-flow design avoids dead-zone temperature variances, ensuring that hardness and metallographic structure are highly uniform across each batch, from surface to core and end to end. - Intelligent control, low energy use
A PLC system recalls process curves with a single click and performs the entire cycle automatically, with traceable data. A full-fiber insulated furnace body, paired with car-type batch processing, keeps running energy consumption under control.
Elik is a company specializing in the R&D and manufacturing of aluminum extrusion processing equipment and industrial furnaces. It provides aluminum profile processors with equipment for ingot pre-treatment, inline post-extrusion handling, and offline heat treatment. Elik possesses the capability to design and deliver fully integrated production lines, with an annual production capacity of 300 energy-efficient heating furnace units and 20 complete production lines.
